XIAO 1.14-inch IPS Display

The board as it appears on the Velxio canvas, with its full pin map read live from the simulator (regenerated by scripts/gen-boards.mjs, so it always matches what you can wire).

Family: Pro boards · Languages: Arduino C++

About this board

An ST7789 135 x 240 IPS panel on a carrier with a pre-soldered XIAO nRF52840 Plus, three user buttons (USR1 D6, USR2 D7 and USR3 on the edge, D19), a Grove I2C connector, a 6-axis IMU and a battery connector. The canvas shows the board front and back; the Grove pads on the back are the ones you wire to.

Drive the panel with Seeed_GFX2, which the board declares for you. Tilt the board and set the battery level from Sensors on the canvas toolbar. The PDM microphone and the I2S pads are not modelled.

Start here

• GraphicTest — Seeed’s ten drawing primitives, timed on the serial monitor.
• Grove SHT31 — a sensor on the Grove connector, sharing the bus with the IMU.
• The three user buttons — each button counted on screen; USR1 toggles the backlight.

Pins (15)

• GND
• 3V3
• SDA
• SCL
• VBUS
• GND.1
• 3V3.1
• GND.2
• D11
• D12
• D13
• D15
• U1
• U2
• U3

Every pin above is clickable on the canvas — click one to start a wire. Board-level behavior, quirks and example links live on the family page.