ESP32-C3 SuperMini
Dieser Inhalt ist noch nicht in deiner Sprache verfügbar.
The board as it appears on the Velxio canvas, with its full pin map
read live from the simulator (regenerated by scripts/gen-boards.mjs,
so it always matches what you can wire).
Family: ESP32-S3 and ESP32-C3 · Languages: Arduino C++, MicroPython, ESP-IDF
About this board
Section titled “About this board”The postage-stamp C3 board that turns up in every parts-bin project — same single-core RISC-V ESP32-C3 as the DevKit, sixteen pins, and almost no board around the chip.
Its inputs are driven by the analog engine like the rest of the catalog, so a switch or divider wired to a GPIO reads the voltage the circuit actually produces rather than an idealised level — see analog simulation.
Start here
Section titled “Start here”No separate starter: open New ESP32-C3 project and swap the board, or place it from Add Component.
Pins (16)
Section titled “Pins (16)”- 5
- 6
- 7
- 8
- 9
- 10
- RX
- TX
- 5V
- GND
- 3V3
- 4
- 3
- 2
- 1
- 0
Every pin above is clickable on the canvas — click one to start a wire. Board-level behavior, quirks and example links live on the family page.