ESP32-CAM
Это содержимое пока не доступно на вашем языке.
The board as it appears on the Velxio canvas, with its full pin map
read live from the simulator (regenerated by scripts/gen-boards.mjs,
so it always matches what you can wire).
Family: ESP32 (classic) · Languages: Arduino C++, MicroPython, ESP-IDF
About this board
Section titled “About this board”The ESP32-CAM is the DevKit’s sensor-carrying cousin: an ESP32 with a 2 MP camera module and a microSD slot, on a board that breaks out only 16 pins because the camera bus claims most of them.
The camera is emulated, not a placeholder — the simulator feeds frames to the firmware, so a webcam sketch produces a real picture in the browser. That is why this board’s starter is the webcam demo rather than a blink: a bare LED sketch would say nothing about the one thing the board exists for.
Start here
Section titled “Start here”- Webcam demo — the camera streaming, the shortest path to seeing the board work.
- Live preview on an ILI9341 — the same frames pushed to a wired TFT.
Pins (16)
Section titled “Pins (16)”- 5V.1
- GND.1
- 12
- 13
- 15
- 14
- 2
- 4
- 3V3
- 16
- 0
- GND.2
- VCC
- RX
- TX
- GND.3
Every pin above is clickable on the canvas — click one to start a wire. Board-level behavior, quirks and example links live on the family page.